Hi, i cant enable bidirectional telemetry - Meteor65

[David-VG]

I am trying to use jesc 48khz but I cant enable bidirectional telemetry:

Log.txt

I also noticed that gyro update frequency is readonly at 8khz

BTFL_cli_Meteor65_20210110_231032.txt

How can I get it working? All ESCs are licensed and uploaded both firmware + telemetry.

[jake-walker]

I'm having the same issue today on a Meteor65, I found that it will still work fine without bidirectional DSHOT enabled. However, when it is enabled, I get 100% error on all the ESCs in Betaflight Configurator, all the sliders are stuck at the bottom on the motors tab, I am missing the two or three notes at the end of the startup chime and the ESCs don't show up in JESC configurator unless I turn it off again and then it all goes back to normal.

After talking with some people about it, on the product page for the Meteor65 it says they ship with firmware O_L_5_REV16_6.HEX on the ESCs. Apparently later versions of the Meteor65 have H type but it could be a possibility that we flashed O-H-5 firmware on to O-L-5 ESCs? I don't know what the differences are between L and H but I'm guessing it shouldn't be working at all for me (when I turn of bi-directional DSHOT) if that was the case.

[David-VG]

I'm having the same issue today on a Meteor65, I found that it will still work fine without bidirectional DSHOT enabled. However, when it is enabled, I get 100% error on all the ESCs in Betaflight Configurator, all the sliders are stuck at the bottom on the motors tab, I am missing the two or three notes at the end of the startup chime and the ESCs don't show up in JESC configurator unless I turn it off again and then it all goes back to normal.

After talking with some people about it, on the product page for the Meteor65 it says they ship with firmware O_L_5_REV16_6.HEX on the ESCs. Apparently later versions of the Meteor65 have H type but it could be a possibility that we flashed O-H-5 firmware on to O-L-5 ESCs? I don't know what the differences are between L and H but I'm guessing it shouldn't be working at all for me (when I turn of bi-directional DSHOT) if that was the case.

Mine finally worked. I've droped the original betaflight+config and started from scratch.

[jake-walker]

Resetting fixed mine as well, it would be useful to know what might be causing the issues in the first place

[odp-ilot]

Disable "SOFTSERIAL" in Betaflight-Configuration should work. Otherwise I couldn't get "bidirectional DSHOT" to run and always had 100% error in the motor tab.