Hi,
I'm using Cisco SG300 (52 port) and I'm using the ZBX-CISCO-INTERFACES templates. This switch is mapping ports 49->1, 50->2 etc..
One thing that I noticed is that I don't get any incoming/outgoing from all the ports, I see only one (ifHCInOctets for example). I do get all the "Speed of interface Ethernet Interface" - but without any names attached to them.
How do I "make" the template start showing all the ports as well as incoming/outgoing graph? (snmpwalk shows all the info)
(I'm using Zabbix 2.4.8, templates: ZBX-CISCO-ENVMON, ZBX-CISCO-HARDWARE, ZBX-CISCO-INTERFACES)
Hi, I'm using Cisco SG300 (52 port) and I'm using the ZBX-CISCO-INTERFACES templates. This switch is mapping ports 49->1, 50->2 etc.. One thing that I noticed is that I don't get any incoming/outgoing from all the ports, I see only one (ifHCInOctets for example). I do get all the "Speed of interface Ethernet Interface" - but without any names attached to them.
How do I "make" the template start showing all the ports as well as incoming/outgoing graph? (snmpwalk shows all the info)
(I'm using Zabbix 2.4.8, templates: ZBX-CISCO-ENVMON, ZBX-CISCO-HARDWARE, ZBX-CISCO-INTERFACES)