I have taken over the marcos for klicky in klipper without any changes and I get the error message shown in the picture
Option 'points' in section 'quad_gantry_level' must be specified
this message comes up even if i only have the klicky-probe.cfg, klicky-variables.cfg and klicky-macros.cfg. I took over all files unchanged. in none of the files can i find the section 'quad_gantry_level.
Simple way to include all the various clicky macros and configurations
I have taken over the marcos for klicky in klipper without any changes and I get the error message shown in the picture Option 'points' in section 'quad_gantry_level' must be specified
this message comes up even if i only have the klicky-probe.cfg, klicky-variables.cfg and klicky-macros.cfg. I took over all files unchanged. in none of the files can i find the section 'quad_gantry_level.
Simple way to include all the various clicky macros and configurations
the current home for this configuration is https://github.com/jlas1/Klicky-Probe, please check it
[include ./klicky-specific.cfg] #place to put other configurations specific to your printer
[include ./klicky-variables.cfg] #Required [include ./klicky-macros.cfg] #Required
[include ./klicky-bed-mesh-calibrate.cfg] #bed mesh, requires klipper configuration
[include ./klicky-screws-tilt-calculate.cfg] #help adjust bed screws automatically
[include ./klicky-quad-gantry-level.cfg] #level 4 Z motors
[include ./klicky-z-tilt-adjust.cfg] #level 2 or 3 Z motors