Love the plugin, have been using it without any issues for quite some time.
Currently, I use the "GCODE Off Delay" with an M81 to have the nozzle cool down a bit after a print, before killing the power.
Is it possible to implement a "Switch off at temperature" with M81 instead of a delay? This way the power can be switched off when the nozzle cools down to, say, 50c.
I know I can use a stopwatch to time the minutes needed for the nozzle to cool down to 50c, but the speed at which it does, is quite variable.
Hi,
Love the plugin, have been using it without any issues for quite some time.
Currently, I use the "GCODE Off Delay" with an M81 to have the nozzle cool down a bit after a print, before killing the power.
Is it possible to implement a "Switch off at temperature" with M81 instead of a delay? This way the power can be switched off when the nozzle cools down to, say, 50c.
I know I can use a stopwatch to time the minutes needed for the nozzle to cool down to 50c, but the speed at which it does, is quite variable.
Looking forward to your thoughts on this.
Regards,
Martijn