Hi,
I'm using PSU control to power on the printer with a GPIO connected to a relay in the PSU of the printer.
I put /home/pi/oprint/bin/octoprint plugins psucontrol:on in the Print Scheduler settings as a system command to run before the prints but it doesn't work. I tried running the line via SSH bridge, it works just fine there.
When I start the printer, the scheduled print will start normally if it was planned.
I had some problems with the old plugin Automatic Shutdown (even if it was deactivated), so I just removed it just in case but it didn't change a thing unfortunately.
Hi, I'm using PSU control to power on the printer with a GPIO connected to a relay in the PSU of the printer. I put /home/pi/oprint/bin/octoprint plugins psucontrol:on in the Print Scheduler settings as a system command to run before the prints but it doesn't work. I tried running the line via SSH bridge, it works just fine there.
When I start the printer, the scheduled print will start normally if it was planned.
I had some problems with the old plugin Automatic Shutdown (even if it was deactivated), so I just removed it just in case but it didn't change a thing unfortunately.