search

jneilliii / OctoPrint-TPLinkSmartplug

105 stars 57 forks source link

[BUG]: #227

Closed shadrak-source closed 3 years ago

shadrak-source commented 3 years ago

Describe the bug I changed the heating cartridge of my hotend to increase the temperature faster, when I set a temperature above 230 °, the connected plug turns off via the plugin. If I turn off TPlink smartplug everything is fine.

To Reproduce Steps to reproduce the behavior:

  1. Go to Octopi
  2. Click on "Set hotend temp. to 250°" After little moment, my smartplug HS110 turn off.

Desktop (please complete the following information):

jneilliii commented 3 years ago

Sounds like you have temperature runaway monitoring enabled. Have you increased the temp there to compensate for your higher temps? Please share screenshots of your settings.

shadrak-source commented 3 years ago

Ok find it, it's not a bug, there is a monitoring for max extruder temp, it was set to 250°, thank you for your help.