Hey, this is not a software issue or design as far as I can tell, just my fat fingers when soldering.
I have the machine built and running, I have a test book on the SD and it opens it BUT
It constantly asks which page I want to go to. (This is the version from October 2022, it just took this long to get the daughter board.)
If i click the middle button or switch pages it will blink the screen and move to whatever page but the navigation prompt just pops back up and keeps asking.
Would it be possible to get which button and pins on the pico are involved in this so I don't have to desolder half this thing?
Hey, this is not a software issue or design as far as I can tell, just my fat fingers when soldering. I have the machine built and running, I have a test book on the SD and it opens it BUT It constantly asks which page I want to go to. (This is the version from October 2022, it just took this long to get the daughter board.) If i click the middle button or switch pages it will blink the screen and move to whatever page but the navigation prompt just pops back up and keeps asking.
Would it be possible to get which button and pins on the pico are involved in this so I don't have to desolder half this thing?
Thanks.