I think it could be a good idea to add to the instructions on how to configure the datalogger that after you set up the local IP the change does not take effect until it is restarted. E.g. disconnected from the inverter. I went far down a rabbit hole chasing to issue with no incoming traffic until I realized this was the issue.
I think it could be a good idea to add to the instructions on how to configure the datalogger that after you set up the local IP the change does not take effect until it is restarted. E.g. disconnected from the inverter. I went far down a rabbit hole chasing to issue with no incoming traffic until I realized this was the issue.