ThxAndBye
commented
7 months ago i have some commands on the eBus that are send every 10sec or so. How would I get ebusd to recognize them?
These are the commands I've seen that I'm sure what they are:
T_WWasser
f151502203cc0e00 / 02fe01 = 10
UIN fe01=510
Mischer1
0751502203900f00 / 02ec00 = 6
UIN ec00=236
Brennerstunden
0708502203de2a02 / 02484a = 13
UIN 484a=19016
Zeitprogramm
0708502203f62702 / 020100 = 6
UIN 0100=1And this is what I've added to the .csv:
u,feuerung,t_wwasser,temperatur_warmwasser,f1,51,5022,03cc0e,t_wwasser,,UIN,10,Grad Celcius,t_wwasser,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,
u,feuerung,mischer_eins,mischer_1,07,51,5022,03900f,mischer_eins,,UIN,10,Grad Celcius,mischer_eins,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,
u,feuerung,bennerstunden,Brennerstunden,07,08,5022,03de2a,brennerstunden,,UIN,,,brennerstunden,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,
u,feuerung,zeitprogranmm,Zeitprogramm,07,08,5022,03f627,zeitprogramm,,UIN,,,zeitprogramm,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,But they aren't added to the MQTT topic. Any help would be appreciated.
ProgWolf18
Hello,
I'm in the process of integrating my Wolf WPM-1 heat pump into Home Assistant running on a Raspberry Pi 4 with an eBus v5 adapter connected via GPIO. The connection seems to work and
ebusctl scan fulldoes also detect the devices on the bus.ebusctl info reports:
But other than
datetimeanderrorI'm not able to receive any data using the csv config from: ebusd-configuration/ebusd-2.x.x/deTrying to read data manually leads in a read error, e.g.:
Is there already a csv config available for the Wolf WPM-1? If not how would I go about decoding the data from the bus and creating a configuration for the device?