No Signal

[moskovskiy82]

Had an adapter 3 board with Wemos. Everthing was working correctly but had to replace the Wemos. Flashed with the mini firmware.

Now i get ebusd connected: yes (inactive) eBUS signal: no signal eBUS initial signal: echo

And in the ebusd logs 2021-12-13 03:57:49.102 [bus error] device status: unexpected enhanced command 0x0e

But if i change the eBUS RX+TX PINs: from Board3 to Direct

I get ebus signal acquired but ebusd throws this errors

2021-12-13 03:52:47.298 [bus info] scan 08 cmd: 3108070400 2021-12-13 03:52:47.571 [main error] scan config 08: ERR: no signal 2021-12-13 03:52:50.302 [main debug] performing regular tasks 2021-12-13 03:52:51.585 [bus debug] ERR: read timeout during receive command ACK, switching to skip 2021-12-13 03:52:52.343 [bus debug] ERR: read timeout during receive command ACK, switching to skip 2021-12-13 03:52:53.122 [main debug] performing regular tasks 2021-12-13 03:53:00.302 [main debug] performing regular tasks 2021-12-13 03:53:03.122 [main debug] performing regular tasks 2021-12-13 03:53:07.571 [main debug] performing regular tasks 2021-12-13 03:53:10.302 [main debug] performing regular tasks 2021-12-13 03:53:13.122 [main debug] performing regular tasks 2021-12-13 03:53:17.572 [main debug] performing regular tasks 2021-12-13 03:53:17.572 [bus info] scan 08 cmd: 3108070400 2021-12-13 03:53:17.844 [main error] scan config 08: ERR: no signal

[moskovskiy82]

As an update Direct mode works just fine

[john30]

are the jumpers set correctly?

[moskovskiy82]

Had to switch to an USB connected to raspberry