search

john30 / ebusd-esp

Firmware for ESP8266 allowing eBUS communication for ebusd (https://github.com/john30/ebusd)
150 stars 21 forks source link

ESP32 HW-665 image #76

Open nyxnyx opened 1 year ago

nyxnyx commented 1 year ago

Hi, I've installed image (factory one since it was first install of image) for ESP32 but it didn't run. My chip is probably a clone of WROOM-32: Chip id is ESP32D0WDQ6 (revision 1) Flash size is 4MB

can someone help?

Filippo125 commented 1 year ago

Hi, same issue with chip id ESP32-D0WD-V3

CherAlban commented 1 year ago

Hi, I am having the same issue trying to flash 20221215 on an "ESP32-D0WD-V3 (revision 3)" on a D1 clone board, using NodeMCU PyFlasher. The serial port repeats:

rst:0x10 (RTCWDT_RTC_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT) configsip: 0, SPIWP:0xee clk_drv:0x00,q_drv:0x00,d_drv:0x00,cs0_drv:0x00,hd_drv:0x00,wp_drv:0x00 mode:QIO, clock div:2 load:0x3fff0030,len:1184 load:0x000002c6,len:738469239 ets Jul 29 2019 12:21:46

Flashing ESPEasy works just fine.

john30 commented 1 year ago

the chip is not the only thing that matters. also the IO association might be different or just not working. so, no other than the variants mentioned in the readme are supported