search

johncarlson21 / SV04-Marlin-2.1.x

Marlin is an optimized firmware for RepRap 3D printers based on the Arduino platform. | Many commercial 3D printers come with Marlin installed. Check with your vendor if you need source code for your specific machine.
http://marlinfw.org
GNU General Public License v3.0
20 stars 7 forks source link

Esteps #7

Closed Piccyman closed 1 year ago

Piccyman commented 1 year ago

**On the esteps adjustment, there should be x and y and z for each extruder. Lovely add-on

johncarlson21 commented 1 year ago

I looked into this for another machine I built and you cannot set the esteps independently for x or y

I've only put this in for the extruder motor

I believe you can set for the z but have not looked into this.

johncarlson21 commented 1 year ago

I will be adding X, Y, Z steps to the next update of the screen and the firmware.

Piccyman commented 1 year ago

Thank you, I did ask a question on Facebook, is linear advance enabled ?

On Mon, 3 Apr 2023, 05:12 John Carlson, @.***> wrote:

I will be adding X, Y, Z steps to the next update of the screen and the firmware.

— Reply to this email directly, view it on GitHub https://github.com/johncarlson21/SV04-Marlin-2.1.x/issues/7#issuecomment-1493622120, or unsubscribe https://github.com/notifications/unsubscribe-auth/A3KPISCCSGXHAPW363O6AHLW7JEZBANCNFSM6AAAAAAV6SAWDA . You are receiving this because you authored the thread.Message ID: @.***>

johncarlson21 commented 1 year ago

Yes it is, and it does have some default set. I'm not really familiar with linear advance etc.. I know if you want to get it just right you need to do some testing.

johncarlson21 commented 1 year ago

This is now updated in the V2.1.3.1b3 pre-release. You also need to update your screen to 1.2.7 Linear Advance is enabled and I've change the K value to 0 so it is basically disabled. You can use a PC to update your values for K.