RFE: Create a Runway, Corridor or Passageway...PIL does not fit the bill

jongough / ocpn_draw_pi

OpenCPN general drawing plug in

8 stars 18 forks source link

RFE: Create a Runway, Corridor or Passageway...PIL does not fit the bill #499

Closed rgleason closed 2 years ago

rgleason commented 2 years ago

Jon, see this request https://www.cruisersforum.com/forums/f134/corridor-passageway-259315.html#post3545364

Is there a way to repurpose PIL to work or create a slightly different object?

jongough commented 2 years ago

The PIL should work, but I found an issue with moving both the start and end points and then trying to select the PIL again. Being based on an EBL most of it was working as needed. I have responded to the post you pointed too. Just not sure if the PIL with two lines that extend to the edge of the OCPN window is what the person wants, but....

rgleason commented 2 years ago

Thanks Jon