Control box motor input polarity

[mmyros]

Hi Jon,

My wire colors are different from your control box figure (Figure 2). Can you provide guidance as to which motor wire (cyan, blue, red, black) goes to which pin (A2, A1, B1, B2)? Sorry if I missed this somewhere in the manuscript.

Thanks Max

[jonnew]

Hi Max,

It doesn't matter, just make sure each winding stays goes to either A or B. A winding can be determined by using a multimeter to test the resistance between wires. If the resistance is low, then those two wires should to A or B. The other two should go to the B or A, respectively.

• Jon

On Tue, May 25, 2021 at 12:31 PM Max Myroshnychenko < @.***> wrote:

Hi Jon,

My wire colors are different from your control box figure (Figure 2). Can you provide guidance as to which motor wire (cyan, blue, red, black) goes to which pin (A2, A1, B1, B2)? Sorry if I missed this somewhere in the manuscript.

Thanks Max

— You are receiving this because you are subscribed to this thread. Reply to this email directly, view it on GitHub https://github.com/jonnew/twister3/issues/2, or unsubscribe https://github.com/notifications/unsubscribe-auth/AAK47YY5MK3NSUZW4LBENWTTPP2NVANCNFSM45QBFYNA .

-- Jonathan Newman Postdoctoral Fellow, MIT http://www.mit.edu/~jpnewman/

[mmyros]

That worked, thanks!

[mmyros]