Closed jriddell closed 4 years ago
Peden says:
Hey I have calibration levels for the falls of Clyde Bonnington linn section of the clyde.
It is based on the Clyde@Tulliford Sepa gauge.
I would say the gauge is:
<0.7 empty 0.7-0.8 scrape* 0.8-0.85 low 0.85-1.0 medium 1.0-1.2 high 1.2-1.3 very high 1.3+ huge
*Below 0.75 it can be run depending on the hydro abstraction but there is no way of telling this without going there.
**I have run it up to 1.1m and seen pictures at 1.2m so beyond this is extrapolation.
***As the hydro abstracts up to 20m3/s the levels vary so these levels should be considered indicative
did this already
Peden says:
Hey I have calibration levels for the falls of Clyde Bonnington linn section of
the clyde.
It is based on the Clyde@Tulliford Sepa gauge.
I would say the gauge is:
<0.7 empty
0.7-0.8 scrape*
0.8-0.85 low
0.85-1.0 medium
1.0-1.2 high
1.2-1.3 very high
1.3+ huge
*Below 0.75 it can be run depending on the hydro abstraction but there is no
way of telling this without going there.
**I have run it up to 1.1m and seen pictures at 1.2m so beyond this is
extrapolation.
***As the hydro abstracts up to 20m3/s the levels vary so these levels should
be considered indicative