The RWR PCB needs additional support near the BIT FAIL button as the PCB excessively flexes when the button is pressed. Or as a workaround add support material at the rear of the PCB (as per photo)
Expected Results/How It Should Work:
Add a extension to the PCB along with a new heat nut in the MCAD above the DISP TYPE switch
Actual Results/How It Does Work:
Screenshots:
More Information
Add an "X" in the square brackets to check the applicable checkboxs.
Category:
Check one or more items.
[X] MCAD (SolidWorks)
[X ] ECAD (PCB Design or other electrical hardware)
Summary:
The RWR PCB needs additional support near the BIT FAIL button as the PCB excessively flexes when the button is pressed. Or as a workaround add support material at the rear of the PCB (as per photo)
Expected Results/How It Should Work:
Add a extension to the PCB along with a new heat nut in the MCAD above the DISP TYPE switch
Actual Results/How It Does Work:
Screenshots:
More Information
Add an "X" in the square brackets to check the applicable checkboxs.
Category:
Check one or more items.
Type:
Check one item.
Applicable End Item:
Check one item.
Associated Filename(s):