OH4A2A1-1 Landing Gear Panel legend and light plate do not cover back plate cutout to PCB at bottom center

[Arribe]

Summary:

The light and legend plates do not extend over a backplate cutout on the landing gear panel. LED backlighing for the DN legend will likely blead out the hole.

Expected Results/How It Should Work:

The cut out for the LED/Resistor should be covered by the light and legend plate.

Actual Results/How It Does Work:

There is a small gap that doesn't cover the backplate cutout fully.

Screenshots:

More Information

Add an "X" in the square brackets to check the applicable checkboxs.

Category:

Check one or more items.

• [x] MCAD (SolidWorks)
• [ ] ECAD (PCB Design or other electrical hardware)
• [ ] Software - Sketch
• [ ] Software - DCS-BIOS
• [ ] Software - Library

  Type:

  Check one item.

• [x] Bug
• [ ] Feature Enhancement
• [ ] Maintenance
• [ ] Question
• [ ] Documentation

  Applicable End Item:

  Check one item.

• [ ] Top Level Assembly
• [ ] Lower Instrument Panel (LIP)
• [ ] Main Instrument Panel (MIP)
• [x] Left Console
• [ ] Right Console
• [ ] Seat
• [ ] Center Tub
• [ ] Flight Stick
• [ ] Throttle
• [ ] General Software

  Associated Filename(s):

  Insert assembly or part file names here, i.e. 123456.sldasm, etc.

[Arribe]

I have this gap in the panel I built, and have seen photos on discord from other builders that also have this gap.

[jrsteensen]

As a workaround, pot it with black RTV or similar.

We will get this in after B1 - trying very hard to not change any PCBs for relatively minor things until there is something that drives us to do more than one thing to a PCB.