Good evening, before making the request I would like to thank the developer for sharing this useful plugin.
While testing this plugin to connect and run commands against a Cisco router, we see that if one of the commands fail, the plugin does not stop and fail the execution, it continues running the following commands.
Looks like Rundeck is not receiving the error signal from the router.
Is there a was to avoid this behavior? Thanks in advance
Good evening, before making the request I would like to thank the developer for sharing this useful plugin.
While testing this plugin to connect and run commands against a Cisco router, we see that if one of the commands fail, the plugin does not stop and fail the execution, it continues running the following commands.
Looks like Rundeck is not receiving the error signal from the router.
Is there a was to avoid this behavior? Thanks in advance