search

jschuh / klipper-macros

A collection of useful macros for the Klipper 3D printer firmware
GNU General Public License v3.0
952 stars 169 forks source link

bed is crashing into Y max position #140

Closed Trei-D closed 1 year ago

Trei-D commented 1 year ago

I have recently installed this on an ender 3 pro using klipper, The problem that I have is that when printer is parking or it's finishing the print, at print show off, the bed is crashing into the Y axis max position.

I went through start_end.cfg since I assume this is the place, but honestly I can't figure out what to modify.

I have reduced the position_max on Y and X, but the problem persisted, and I lose print space as well.

Could you please direct me to the right place?

Later edit: I did found the problem with the Y max position. I had a new belt tensioner which took 3 mm from the printing area. I adjusted it within the printer cfg and the problem solved.

lsljunior commented 5 months ago

Hello! I'm having exactly the same issue, but my printer is a neptune 3 pro. What exactly did you change in printer.cfg? Thanks in advance

Trei-D commented 5 months ago

I have reduced the bed size in printer.cfg. Also I had a belt tensioner which was taking space.

On Fri, May 3, 2024, 03:56 lsljunior @.***> wrote:

Hello! I'm having exactly the same issue, but my printer is a neptune 3 pro. What exactly did you change in printer.cfg? Thanks in advance

— Reply to this email directly, view it on GitHub https://github.com/jschuh/klipper-macros/issues/140#issuecomment-2091969686, or unsubscribe https://github.com/notifications/unsubscribe-auth/APEPIAZLFL7GIDPLF5GZL43ZALOCHAVCNFSM6AAAAAAZSRAM6KVHI2DSMVQWIX3LMV43OSLTON2WKQ3PNVWWK3TUHMZDAOJRHE3DSNRYGY . You are receiving this because you modified the open/close state.Message ID: @.***>