search

jstrausd / homebridge-simple-wled

Homebridge Plugin to control WLED LED-Strips
ISC License
64 stars 18 forks source link

Device not showing in HomeKit #26

Closed TristanGrahn closed 2 years ago

TristanGrahn commented 3 years ago

The device is shown under "Accessory's" in home-bridge where I can control the brightness and effects, however it is not showing in the HomeKit app

MarkARushton commented 3 years ago

Did you have any luck with this? I’m facing the same issue

TristanGrahn commented 3 years ago

Hey yes so once you have it working, you can check using the assecorys in homebridge. Then go to the plug-in and plug-in in options then bridge the plug-in and a we code will pop up and then scan that in HomeKit and the device will pop up

Best Regards Tristan

Student Number 219012853 Email Address @.**@.> Student Contact 0795888529 Academic Year 2021 Qualification B6ELSQ - BEng in Electrical & Electronic Eng Offering Type VT - APK CAMPUS FULL-TIME Block 0 - YEAR BLOCK Period of Study 2 - SECOND YEAR

On 03 Oct 2021, at 03:11, Mark @.***> wrote:



Did you have any luck with this? I’m facing the same issue

— You are receiving this because you authored the thread. Reply to this email directly, view it on GitHubhttps://github.com/jstrausd/homebridge-simple-wled/issues/26#issuecomment-932843490, or unsubscribehttps://github.com/notifications/unsubscribe-auth/ATRTEJUL3Y22XWDADQ5B5FTUE6UTBANCNFSM5FCU4G3Q.

MarkARushton commented 3 years ago

Hello - I tried this but was unable to see how to switch which effect is being used. I also couldn't find the code to scan on the phone to get the plugin to show. My other devices are appearing on my phone with no issues.

jstrausd commented 3 years ago

You have to add the device manually in the HomeKit App, for that go into the HomeKit App and hit the plus button at the top right > Add Device > Hit the button at the bottom, where it says you do not have a code or cannot scan it. Here the device should appear and you can use your Homebridge PIN (the pin which is displayed under the QR-Code) to pair this device. I hope this answer solves your problem