APM Planner not remembering battery breakout board settings

[GoogleCodeExporter]

I set the APM planner to use a 180A voltage breakout board, the details appear 
to be calculated correctly and the 180A option shows in the drop down box.

If I then navigate away from that page and go back to the Flight data screen 
all is well and the voltage is correctly shown.

If I then disconnect and close down the planner and then later re open and 
reconnect and go back to the battery screen, the drop down box now shows other 
instead of the 180A selection.

If I reselect the 180A option, all the figures change and get recalculated 
(correctly I might add).

Original issue reported on code.google.com by QandG...@gmail.com on 15 Mar 2012 at 9:15

[GoogleCodeExporter]

what version of firmware are you using?

Original comment by Meee...@gmail.com on 15 Mar 2012 at 11:27

[GoogleCodeExporter]

Arducopter 2.4.1. The issue is with the drop down in the planner, the actual 
breakout board settings are being remembered by the apm.

Original comment by QandG...@gmail.com on 16 Mar 2012 at 7:39

[GoogleCodeExporter]

i will fix

Original comment by Meee...@gmail.com on 21 Mar 2012 at 11:49

[GoogleCodeExporter]

Original comment by Meee...@gmail.com on 21 Mar 2012 at 12:15

• Changed state: Fixed

[GoogleCodeExporter]

Not seeing an change on this one. It still shows as 0:other if I change it to 
4:180a and then navigate away from the battery setting screen and then go back 
to it.

It does correctly show up in the configuration parameters on the left as 
battery sensor 4.  I am running version 1.1.56.

Original comment by QandG...@gmail.com on 24 Mar 2012 at 12:00