Open Karmenzind opened 2 years ago
got the same error with gvim. Anyone know how to fix it?
It prompted "Press ENTER or type command to continue" (no other message).
You can check the previous error messages with :messages
command.
This is still not working at all on Windows in 2024. Literally following the exact instructions on the webpage results in this error. Is it just not going to be addressed?
Works for me just fine. FWIW, a common mistake on Windows is to put the plug section in gvimrc instead of vimrc.
You should check if Vim is properly loading the autoload files by examining the output of :scriptnames
.
It also happend in my device
I also encountered the same issue. It turned out I did not have git installed. Easy to overlook when you normally always use Linux... 😄
Happening in my device too
Followed the instructions but yet not working
I followed the instruction to install vim-plug and created a minimal config file
_vimrc_temp
(only 3 lines)then started Vim with
vim -u .\_vimrc_temp
. It prompted "Press ENTER or type command to continue" (no other message). Then I pressed ENTER and executed:PlugInstall
and it raisednot an editor command
:The whole config file:
I also tried some paths like:
environment