I've updatd the extruder dimensions and gantry height for both Prusa and Cura slicer to have better support for sequential printing.
Along the way I ran into various quirks with both the hardware and Ankerslicer. They've been documented in the known issues. Most notable are the following issues:
Adjusting the fan speed from the display during print, will cause the fan speed to no longer regulate itself in subsequent objects. It will keep the set fan speed until the end of the object, drop down to the 'first layer(s)' setting and then remain at that. It will no longer spin back up.
Pausing the print from the display during printing, will cause the extruder to move directly to FRONT left of the build plate. It will not raise the Z-axis and thus will collide with any objects along it's path.
Also for anyone noticing I've set the gantry height to 23mm rather than 30mm, this is correct. On the left of the extruder there's a small plastic rod poking out to the x-axis end stop. This rod is about 7mm lower than the gantry at it's lowest point.
I've updatd the extruder dimensions and gantry height for both Prusa and Cura slicer to have better support for sequential printing.
Along the way I ran into various quirks with both the hardware and Ankerslicer. They've been documented in the known issues. Most notable are the following issues:
Also for anyone noticing I've set the gantry height to 23mm rather than 30mm, this is correct. On the left of the extruder there's a small plastic rod poking out to the x-axis end stop. This rod is about 7mm lower than the gantry at it's lowest point.