search

k3ng / k3ng_rotator_controller

K3NG Arduino Amateur Radio Rotator Controller
http://blog.radioartisan.com/yaesu-rotator-computer-serial-interface/
GNU General Public License v3.0
179 stars 125 forks source link

Problem Integrating GY-NEO-6M with K3NG Rotator Controller #107

Closed gdmcintire closed 7 months ago

gdmcintire commented 9 months ago

I'm building up a K3NG rotator controller on a Mega2560. I've successfully integrated a relay shield, az and el incremental encoders, and a Nextion 3.5 inch HMI. Now I am trying to integrate a GY-NEO6MV2 GPS. First, I implemented a sketch on an UNO using the Tiny GPS++ library. It works fine on the UNO...sync, using 11 satellites, correct position, etc. The K3NG sketch doesn't seem to be processing the GPS data correctly however. The display still shows the HL59 as the grid. I assigned pin 53 to GPS_SYNC and it does not indicate sync with the K3NG sketch. I tried substituting the Tiny GPS++ library for the Tiny GPS in the code but it wouldn't compile. Are others successfully using the GY-NEO6MV2 with the K3NG sketch and if so, what did you have to do to get it to work?

Greg, AA5C

gdmcintire commented 7 months ago

Got a NEO-8 and it only outputs $GP messages. $GN and $B messages were confusing the TinyGPS library. Works now. No responses on the forum in almost two months.

sv2sih commented 7 months ago

thank you very much sorry for my english i use translator i will try it and if i have any problem i will contact you again thank you again good afternoonKousaxidis Zisis 735 Απρ 2024, 23:29, ο χρήστης «gdmcintire @.***>» έγραψε: Got a NEO-8 and it only outputs $GP messages. $GN and $B messages were confusing the TinyGPS library. Works now. No responses on the forum in almost two months.

—Reply to this email directly, view it on GitHub, or unsubscribe.You are receiving this because you are subscribed to this thread.Message ID: @.***>