Good morning,
I have looked but cannot find answers. My MZ2 with minie3v3 works except for the Z axis not stopping even if I activate the bltouch by hand and just crashes on the build plate.
I have tried:
Flashed amz2_btt_minie3v3_bl-bugfix-2.1.x-20221002-firmware.bin
Initialize eeprom, home x is ok, home y is ok, home Z CRASHES.
Stopping it above the plate by touching the probe or the z stop switch.
Disconnect Z stop and reinitialize but even when touching probe wont stop and crashes to plate.
Connections compared based on my previous SKR Mini MZ and diagrams for both e3v3 and MZ boards. Also see picture I used below for BLtouch cable colors.
Any help appreciated! Also, the non BL firmware works ALL limit switches fine, but not the bl.
Good morning, I have looked but cannot find answers. My MZ2 with minie3v3 works except for the Z axis not stopping even if I activate the bltouch by hand and just crashes on the build plate.
I have tried: Flashed amz2_btt_minie3v3_bl-bugfix-2.1.x-20221002-firmware.bin Initialize eeprom, home x is ok, home y is ok, home Z CRASHES. Stopping it above the plate by touching the probe or the z stop switch. Disconnect Z stop and reinitialize but even when touching probe wont stop and crashes to plate.
Connections compared based on my previous SKR Mini MZ and diagrams for both e3v3 and MZ boards. Also see picture I used below for BLtouch cable colors.
Any help appreciated! Also, the non BL firmware works ALL limit switches fine, but not the bl.