I just installed the PSU Control plugin and PSU Control - Home assistant plugins and configured them. Now when I turn the printer back on Octoprint does not automatically connect.
Turn PSU off with Home Assistant
Turn PSU on with Home Assistant
...
What did you expect to happen?
I expected the PSU to turn on (it did) and Octoprint to connect to the printer.
What happened instead?
Octoprint did not connect, I received errors in the log and see the following on the Octoprint page
State: Offline after error
SerialException: device reports readiness to read but returned no data (device disconnected or multiple access on port?)
No serial port found, are you sure your printer is physically connected and supported? Try [refreshing](javascript:void(0)) and if that doesn't help please see [the FAQ](https://faq.octoprint.org/no-candidates).
I also cannot manually connect without restarting Octoprint. I get the following message:
Could not autodetect your printer
No working connection parameters could be found. Are you sure your printer is physically connected and supported? Refer to [the FAQ](https://faq.octoprint.org/connection-error) for help in debugging this.
Version of OctoPrint-PSUControl
1.0.6
Operating System running OctoPrint
OctoPi
Printer model & used firmware incl. version
CR-10 with SKR 1.3 board running some version of Marlin
Link to octoprint.log with octoprnt.plugins.psucontrol set to DEBUG
What were you doing?
I just installed the PSU Control plugin and PSU Control - Home assistant plugins and configured them. Now when I turn the printer back on Octoprint does not automatically connect.
What did you expect to happen?
I expected the PSU to turn on (it did) and Octoprint to connect to the printer.
What happened instead?
Octoprint did not connect, I received errors in the log and see the following on the Octoprint page
I also cannot manually connect without restarting Octoprint. I get the following message:
Version of OctoPrint-PSUControl
1.0.6
Operating System running OctoPrint
OctoPi
Printer model & used firmware incl. version
CR-10 with SKR 1.3 board running some version of Marlin
Link to octoprint.log with octoprnt.plugins.psucontrol set to DEBUG
https://pastebin.com/YjTNZGfg