search

kejar31 / VoronMods

Mods I have created for my Voron printer
GNU General Public License v3.0
128 stars 15 forks source link

Can't Get Connector Through Cable Gland Mount #7

Closed Alexander-T-Moss closed 1 year ago

Alexander-T-Moss commented 2 years ago

I don't know if this is a "me" issue but when I was installing my CB-C2 I had to cut the molex connector off one end of the harness I was using to get it through the cable gland mount as the 4 pin molex connector for the EBB36 won't go through the cable gland mount. So would it be possible to modify the mount to have a cutout in the side of it so once I unscrew the cable gland, the harness will slide in and out through the side? ( I played around in CAD and will test it out when I reprint the parts in PCCF )

Modified Cable Gland.zip

image
kejar31 commented 2 years ago

Humm this isn’t a bad idea… I will test this out later and may implement it.. will def give you credit etc

Alexander-T-Moss commented 2 years ago

As a quick bodge I just cut a section out of the original one I had installed and there doesn't seem to be any issue with it. Unfortunately I'll not be able to test out printing it with the cutout as I'm now away from my printer for two weeks :)

Alexander-T-Moss commented 2 years ago

Having tested the alternate cable gland mount I can verify it works without issue :) 0824F080-30E3-49E3-8AAD-CB8388397FDA

kejar31 commented 1 year ago

As I am looking to do and upgrade to this project.. I am going to give this a good look.. if used you will have solved an annoying issue. Thank you sir!

Alexander-T-Moss commented 1 year ago

No problem 🙂

kejar31 commented 1 year ago

I did end up using this, thank you again good sir