search

kennetek / gridfinity-rebuilt-openscad

A ground-up rebuild of the stock gridfinity bins in OpenSCAD
Other
1.15k stars 166 forks source link

Tab support unecessary #86

Open kennetek opened 1 year ago

kennetek commented 1 year ago

Tabs can be entirely flat underneath if your printer's bridging is good. See #73.

mrcpu99 commented 1 year ago

I would hate to see the support go away on the tab. I get that everything perfect it's unnecessary. I could get behind a toggle that perhaps turned it off or on, but me personally, even though my printer is in good shape, I still use it as little as possible...

On Fri, Mar 17, 2023 at 11:05 AM Kenneth @.***> wrote:

Tabs can be entirely flat underneath if your printer's bridging is good. See #73 https://github.com/kennetek/gridfinity-rebuilt-openscad/discussions/73.

— Reply to this email directly, view it on GitHub https://github.com/kennetek/gridfinity-rebuilt-openscad/issues/86, or unsubscribe https://github.com/notifications/unsubscribe-auth/AJZT3EJXF7NRH7WLKOZDCALW4SRYJANCNFSM6AAAAAAV62ZWGM . You are receiving this because you are subscribed to this thread.Message ID: @.***>

kennetek commented 1 year ago

Do not worry! It would be a toggle. All new features are always a choice, the base bins will always stay the same.

mphardy commented 8 months ago

If you set a_tab=10 you essentially get this result already.