I am trying to install wire-prod-pod on a Windows 10 64-bit PC. I followed the instructions and everything went through successfully until the point of starting chipper. I then receive a segmentation fault at line 40 of the start.sh file. My command lines are attached that show the completion of the setup process and then the attempt to start chipper.
Any ideas on what might be causing this? Any fixes?
Hello!
I am trying to install wire-prod-pod on a Windows 10 64-bit PC. I followed the instructions and everything went through successfully until the point of starting chipper. I then receive a segmentation fault at line 40 of the start.sh file. My command lines are attached that show the completion of the setup process and then the attempt to start chipper.
Any ideas on what might be causing this? Any fixes?
Thank you.