Just leaving a note here that if your vector has 2.0 firmware it will not work (from my experience) with wire pod. So you have to downgrade it to 1.8. And to do that, you have to access the specific vector setup link https://keriganc.com/vector-epod-setup, as stated in the readme of this project. But if you have linux and try to connect it through chromium (of course, i adjusted the flags and so on), it will have issues. However, I managed to pair it with the phone using chrome, so I guess it works with android phones... again, from my experience.
I finally brought my little bot back to life last night after doodling quite a while with it (mainly due to the firmware version and the linux issue). But it works on linux based computers, I tried with ubuntu on a dell and with Pi 400 and it works flawlessly.
Other than that, the project is amazing. Congratz!
Just leaving a note here that if your vector has 2.0 firmware it will not work (from my experience) with wire pod. So you have to downgrade it to 1.8. And to do that, you have to access the specific vector setup link https://keriganc.com/vector-epod-setup, as stated in the readme of this project. But if you have linux and try to connect it through chromium (of course, i adjusted the flags and so on), it will have issues. However, I managed to pair it with the phone using chrome, so I guess it works with android phones... again, from my experience.
I finally brought my little bot back to life last night after doodling quite a while with it (mainly due to the firmware version and the linux issue). But it works on linux based computers, I tried with ubuntu on a dell and with Pi 400 and it works flawlessly. Other than that, the project is amazing. Congratz!