search

khunpoum / Marlin-2-for-Sapphire-Plus-V2-gen2

Marlin v2 for Sapphire Plus V2 (gen2)
GNU General Public License v3.0
13 stars 9 forks source link

Sapphire gen 2 ? #2

Open telemac73 opened 3 years ago

telemac73 commented 3 years ago

Hello, I try to upgrade my sapphire plus gen 1 to 2 , can you just confirm me the only difference is a stepper on E1 , remove the belt and naturally change cable to the motor ? Thanks )

ivan-krapivtsev commented 3 years ago

You probably also need to install second Z endstop.

telemac73 commented 3 years ago

Hello,

Ok thanks.

And i remove belt ? i see some printer with 2 z axe that also use a belt for sync.

Thanks and have a nice day.

De : Ivanmailto:notifications@github.com Envoyé le :lundi, 4 janvier 2021 15:07 À : khunpoum/Marlin-2-for-Sapphire-Plus-V2-gen2mailto:Marlin-2-for-Sapphire-Plus-V2-gen2@noreply.github.com Cc : telemac73mailto:telemac73@hotmail.com; Authormailto:author@noreply.github.com Objet :Re: [khunpoum/Marlin-2-for-Sapphire-Plus-V2-gen2] Sapphire gen 2 ? (#2)

You probably also need to install second Z endstop.

— You are receiving this because you authored the thread. Reply to this email directly, view it on GitHubhttps://github.com/khunpoum/Marlin-2-for-Sapphire-Plus-V2-gen2/issues/2#issuecomment-753994396, or unsubscribehttps://github.com/notifications/unsubscribe-auth/AI4JTW7BH6KYLTLLQVCUSR3SYHDSZANCNFSM4VQ5FFIA.

tektonik99 commented 3 years ago

Hello,

Thank you for this marlin fork. I'm considering updating it to my printer. Not sure which version I have, two z motors connected with belt on two TMC2225 drivers, with only one Z end stop switch. It came like this, other drivers are TMC2208. I'm also thinking of adding BL touch sensor. Should I then remove Z end stop, keep the belt for Z motors, turn on BL touch in firmware, and it should work without any other changes?

All the best