I think that reshaping configuration is too unclear
The current window is:
Corner smoothness:
[----
--\
--
----]
vertical
backward
outward
left
position
[]
[]
[]
direction
[]
[]
[]
right
position
[]
[]
[]
direction
[]
[]
[]
New mode:
Settings
Roll:
[_]
Inclination:
[_]
Yaw:
[_]
Width:
[_]
Offset from center:
[_]
Backwards:
[_]
Vertical offset:
[_]
Node smoothing/nodeless
[ ]
You can switch between both modes using "Simple" and "Advanced" options:
You can select only one mode per segment.
Advanced mode interpolates final numbers (not entered ones)
Simple node interpolates settings, then applies generated output
I think that reshaping configuration is too unclear
You can switch between both modes using "Simple" and "Advanced" options: You can select only one mode per segment. Advanced mode interpolates final numbers (not entered ones) Simple node interpolates settings, then applies generated output