search

kliment / Printrun

Pronterface, Pronsole, and Printcore - Pure Python 3d printing host software
GNU General Public License v3.0
2.38k stars 998 forks source link

ini file printface #1217

Open ken58w opened 3 years ago

ken58w commented 3 years ago

its not making the ini file for wifi why what is going on ? RECV: Connect fail, please check your INI file or set the wifi config and connect again

ken58w@yahoo,com

volconst commented 3 years ago

This message does not come from Pronterface, just received by it. It comes either from your printer or your router - you should check their INI.

ken58w commented 3 years ago

its a wifi card sd unit not a ptinter its demo on utube for this card SD-WIFI with Card-Reader Module run ESP web Dev Onboard

ken58w commented 3 years ago

it is not printer or router it is a FYSETC wifi sd card unit SD-WIFI with Card-Reader Module run ESP web Dev Onboard the utube demo show it programing card https://www.youtube.com/watch?v=nHNZPRl8gzA

volconst commented 3 years ago

See https://github.com/FYSETC/FYSETC-SD-WIFI Fill the wifi network name and pass in this file https://github.com/FYSETC/ESPWebDAV/blob/fysetc/ini/SETUP.INI and copy it to the card root (either by ordinary card reader or the non USB2UART switch state, or use M50,M51,M52 commands to connect, then map network drive)