Reaver: Failed to associate

[GoogleCodeExporter]

0. What version of Reaver are you using?  (Only defects against the latest
version will be considered.)
1.4
1. What operating system are you using (Linux is the only supported OS)?
backtrack 5 r2

2. Is your wireless card in monitor mode (yes/no)?
yes

3. What is the signal strength of the Access Point you are trying to crack?
81

4. What is the manufacturer and model # of the device you are trying to
crack?
unknown (challenge from boss)

5. What is the entire command line string you are supplying to reaver?
reaver -i mon0 -b 00:1C:F0:08:F7:B0 -w
6. Please describe what you think the issue is.
So on a $10 bet with my boss (I work front desk in a hotel) that someone with 
moderate computer knowledge and access to the internet can easily crack a wpa 
password.

I think the problem may be that the wifi device is not compatible? is there a 
way to find out what the model is remotely? if not is there any way i could 
make this work? 

Original issue reported on code.google.com by FlyingMo...@gmail.com on 2 Jul 2012 at 4:42

[GoogleCodeExporter]

here is my complete commands

iwconfig
airmon-ng start wlan0
airodump-ng mon0
reaver -i mon0 -b 00:1C:F0:08:F7:B0 -w

Original comment by FlyingMo...@gmail.com on 2 Jul 2012 at 4:44

[GoogleCodeExporter]

You should try wash -i mon0 to see if his router is supported (has wps enabled)

Original comment by xFxIxC...@gmail.com on 9 Jul 2012 at 1:53