search

kostakis52 / ardupilot-mega

Automatically exported from code.google.com/p/ardupilot-mega
0 stars 0 forks source link

Stabilize mode stops RC input from reaching servos and Speed control #379

Closed GoogleCodeExporter closed 9 years ago

GoogleCodeExporter commented 9 years ago 
What steps will reproduce the problem?
1.Place APM in SABILIZE MODE VIA transmitter
2.
3.

What is the expected output? What do you see instead?
I should still be able to send RC commands from the TX to the servos

What version of the product are you using? On what operating system?
2.2.1 APM code Windows 7

Please provide any additional information below.
If I set the mode via the TX to manual and set the mode to stabilize via the 
mission planner, I can still pass RC commands via the TX.

Original issue reported on code.google.com by bill.snyder.bs@gmail.com on 17 Jul 2011 at 5:58

GoogleCodeExporter commented 9 years ago 
that is correct. in any mode, transmitter stick still have function. including 
auto. This is an option that can be turned on and off when compiling yourself.

Original comment by Meee...@gmail.com on 20 Jul 2011 at 5:05

GoogleCodeExporter commented 9 years ago 
Perhaps I did not explain the issue properly. I have no stick throughput unless 
the manual mode is selected.

Original comment by bill.snyder.bs@gmail.com on 20 Jul 2011 at 10:16

GoogleCodeExporter commented 9 years ago 
have you setup your radio? CLI > setup > radio?

Original comment by Meee...@gmail.com on 20 Jul 2011 at 10:54

GoogleCodeExporter commented 9 years ago 
Yes I did. Does this work for other folks?

Original comment by bill.snyder.bs@gmail.com on 21 Jul 2011 at 2:35

GoogleCodeExporter commented 9 years ago 
Please close this. Turns out i I had a defective cell in the battery which 
caused intermittent results but for sure caused the problems I was seeing.

Original comment by bill.snyder.bs@gmail.com on 23 Jul 2011 at 3:01

GoogleCodeExporter commented 9 years ago

Original comment by Meee...@gmail.com on 28 Jul 2011 at 3:11