Closed cssi-dev closed 1 month ago
You mean move this Issue to the other repo?
Yeah it'll get more attention over there.
This repo was setup when I first built the guide before it was adopted by BTT. It's maintained on their official repo now.
Instructions etc have changed which could also solve some issues
Ok, thank you
I tried printing the first part after switching to the new probe. I was suprised to learn, that my print was canceled during the print start macro. Error:
with
horizontal_move_z: 5
So I switched it to
horizontal_move_z: 10
(even though In the bed section the horizontal_move_z is just 2 ), to then get the nozzle crash because the printer after getting all the readings moved all z axes way to far.I get that you are not supposed to use the eddy coil for homing because of the temprature drift. But please let us use the Tilt adjust. I don't want to switch every 5-10 prints between the probes just to readjust the z axis when it gets out of wack.
Steps to reproduce:
Z_TILT_ADJUST