search

kulamario / ReAmiga-1200-Mouse-USB

9 stars 1 forks source link

... very interesting project ! ... but ... #2

Open drwhy75 opened 2 years ago

drwhy75 commented 2 years ago

Hi !

Found this project some months ago. Liked it very much, so I tried to build the adapters. So far I have build two of them, but none of them are showing any life signs when connected to my ReAmiga1200 Rev1.1 & 1.2.

I have flashed the FW using a cheap ST-Link V2 dongle. The programming was finished after 6 seconds, verifying is ok, comparing the data from the chip to the .bin-file looking good too ... I hope I use the right crystal ?!?

IMG_8635 What USB-Mice are supported ?

..so what I am doing wrong here ?

Any chance to get some support here ?

kulamario commented 2 years ago

Crystal 8mhz should be Mouse I use this one https://a.aliexpress.com/_mLBk0dG Should working almost all HID

drwhy75 commented 2 years ago

... ahhh ! Thank You ! ... when you take a look at the circuit diagram in Eagle, there is a "Farnell-Partnumber" pointing to the 3,68MHz Crystal ! That's the reason I used the wrong ones !