Open josemabcn opened 1 year ago
Firmware should be compiled for AVR atmega2560, I'm not sure about the other questions. Perhaps you can post a picture?
Yes, when yo configure to complie the firmware for the printer, the menus shows:
Thanks,
Jose
For GPIO pins set at micro-controller startup, I don't think you need to select anything.
For the other stuff, I think that looks right!
Thanks for your reply, my last questions is about how to update the firmware, the results form the compile step its a klipper.elf and klipper.elf.hex files. How I can update the firmware?, copy the klipper.elf.hex directly to a SD Car, turn off the printer and turn ON and automatically the printer update the firmware?, I need to rename the klipper.elf.hex file with another name?.
Sorry for the questions...
No worries about asking questions! Happy to try and answer them best I can :)
I don't remember to be honest with you. I remember the PI did all the work when I first set up Klipper (including firmware upload). To be honest, I haven't updated anything since then.
I use mainsailos, perhaps that would be useful? https://docs-os.mainsail.xyz/
Please, can you share how to build the firmware for the printer?, What microcontroller, processor, etc, and specially the GPIO pins set at micro-controller startup?.
Thanks I'm stopped in this part in order to change the printer from Marlin to Klipper.
Thanks in advance,
Jose