search

kusti8 / OpenHWControl

A cross platform open source tool to control NZXT components easily through software
GNU General Public License v3.0
53 stars 3 forks source link

Windows 10x64 NoBackendError #2

Open mircoker opened 7 years ago

mircoker commented 7 years ago

This happens on start of application. Installation is normal.

3

akej74 commented 7 years ago

I had similar problems when trying to get Kraken support in Grid Control. Have a look at my Readme and "LibUSB installation", not sure if this is applicable for OpenHWControl but it may be worth installing the DLL's manually and see if that help. I never managed to get furhter with this in Grid Control.

kusti8 commented 7 years ago

Libusb is shipped with the exe but in a pip install it is not included and must be installed manually. I haven't gotten around to adding it and you should use the exe for Windows.

On Sat, Apr 22, 2017, 11:47 AM Åke Johansson notifications@github.com wrote:

I had similar problems when trying to get Kraken support in Grid Control. Have a look at my (Readme)[https://github.com/akej74/grid-control] and "LibUSB installation", not sure if this is applicable for OpenHWControl but it may be worth installed the DLL's manually.

— You are receiving this because you are subscribed to this thread. Reply to this email directly, view it on GitHub https://github.com/kusti8/OpenHWControl/issues/2#issuecomment-296382003, or mute the thread https://github.com/notifications/unsubscribe-auth/AJW73Fh5t5oc2Vwdx6AWmqvWqceBbQXIks5ryiELgaJpZM4NFGPe .

virtual812 commented 7 years ago

Used the exe installer and ended with the same result as the OP. Any suggestions on what i might try?