Rev B Issues - Githubissues

lab11 / buckler

Development board for teaching embedded systems

MIT License

5 stars 11 forks source link

Rev B Issues #2

Closed brghena closed 3 years ago

brghena commented 6 years ago

[x] Add silkscreen label for switch position high/low
[x] Put IC part numbers on the silkscreen

brghena commented 6 years ago

[ ] Got the RX and TX pins reversed on the Kobuki connection (sigh). Totally fixable in hardware, but we should change it for future revisions.
[x] Label SD_DETECT test point

brghena commented 6 years ago

[x] 3v3 label is confusing since Vcc is actually less than 3 volts...
[x] Use some labeling to show hole connection to the signals

adkinsjd commented 6 years ago

[x] Move the gyro/accel axis label out from under the screen

nealjack commented 4 years ago

I just committed a fix for most of these issues. I'm not sure what "Use some labeling to show hole connection to the signals" means. Does that mean have silk lines connecting the parallel holes on the side of the board?

brghena commented 4 years ago

It wasn't clear to some students that the holes were the same thing as the soldered pins. Probably safe to ignore. Alternatively a silkscreen line from the hole to the pin might be good if you think it's warranted.