search

labradore / unojoy

Automatically exported from code.google.com/p/unojoy
0 stars 0 forks source link

Windows batch file wont run #6

Open GoogleCodeExporter opened 8 years ago

GoogleCodeExporter commented 8 years ago 
I followed all the steps and ran the windows batch file. My output was this:

Abracadabra!

C:\Users\adam\Downloads\UnoJoyWin-15May2012\UnoJoyWin\ATmega8u2Code\HexFiles>bat
chisp -device at90usb82 -hardware usb -operation erase f memory flash blankcheck
 loadbuffer "UnoJoy.hex" program verify start reset 1024
Running batchisp 1.2.5 on Mon Oct 15 17:26:20 2012

AT90USB82 - USB - USB/DFU

Device selection....................... PASS
Hardware selection..................... PASS
Opening port........................... AtLibUsbDfu: 3EB 2FF7 no device present.

FAIL    Could not open USB device.
ISP done.

-1
The firmware was NOT loaded...

Did you install the Atmel FLIP program? - http://www.atmel.com/tools/FLIP.aspx -

Is the Arduino plugged in?
Is is it in 'Arduino UNO DFU' mode?
Press any key to exit..

The arduino is plugged in and in DFU mode although it shows as the ATmega16U2 
not the arduino DFU mode under system devices. Any solutions?

Original issue reported on code.google.com by ccoreg...@gmail.com on 15 Oct 2012 at 11:37

GoogleCodeExporter commented 8 years ago 
Hi there - Did you install the Atmel Flip program? What OS are you running? Is 
it the 32 or 64 bit version?  If it's showing up as the ATmega16U2, that's what 
it should show up as in DFU mode.

Original comment by alan.chatham@gmail.com on 17 Oct 2012 at 8:31

GoogleCodeExporter commented 8 years ago 
Ive encountered this...

Im assuming your trying this on the "UNO". If you are having problems getting 
the Arduino board to show as being in DFU mode then it could be that you are 
using an "R1" version of the "UNO". flip the board over and if you dont see 
"R2" or "R3" Then its a Revision 1 board and requires an extra step to place it 
in "DFU" mode.

Go to this site:
https://www.virtuabotix.com/?p=673

half way down under the heading "For version One only" is possibly all you need 
to sort this issue.

Original comment by matiuteh...@hotmail.com on 4 Jan 2013 at 7:02

GoogleCodeExporter commented 8 years ago 
I have the same problem with REV 3.
What can I do ?

Original comment by claude.e...@gmail.com on 29 May 2014 at 11:54

GoogleCodeExporter commented 8 years ago 
Plus I'm unable to go back into Arduino mode.
The batch says : "Atlibusbdfu : 3 EB 2FF7" no device present FAIL couldnot open 
sb device.
I can't use my arduino anymore for now.

Original comment by claude.e...@gmail.com on 29 May 2014 at 11:57