system configuration / calibration

larus-breeze / sw_sensor

Firmware for Larus sensor MK1 and MK2

3 stars 3 forks source link

Closed MaxBaex closed 2 years ago

MaxBaex commented 3 years ago

Read vom SD Card? Store in Flash memory?

Bluetooth Name setting
Calibration parameter for cheap IMU (Identify by using the STM32F4s UUID)
Mode (1 GPS, 2 GPS, ) , Low-Cost IMU, High-Cost IMU (or just use High-Cost if available)
Add a configuration file parser: https://github.com/zserge/jsmn https://github.com/DaveGamble/cJSON ...?
Will there be some system configuration which affects the behaviour of the vario?

MaxBaex commented 3 years ago

EEPROM configuration parameters shall be dumped to the SD card for analysis purpose.
On startup:

1st Check if new configuraion on SD-card exists. (use a simple checksum to compare (config.json)
2nd Load new configuration and store it to EEPROM
3rd Dump written configuration (config_dump.json)
4rd Dump calibration parameter to SD-card if updated. (calibration_dump.json)

Start Vario functionality after these initial steps.

MaxBaex commented 3 years ago

Test with Aircraft Registration and Bluetooth Device Name.

MaxBaex commented 3 years ago

The height difference of the second differential GNSS antenna shall be configurable.

MaxBaex commented 3 years ago

configure sensor orientation relative to the airplane

MaxBaex commented 2 years ago

Implemented by @realtimepeople