search

levylabpitt / AFM-Lithography

BSD 3-Clause "New" or "Revised" License
7 stars 0 forks source link

Administrator Mode #98

Open ciozi137 opened 1 year ago

ciozi137 commented 1 year ago

Saving configuration to c:\ProgramData\ requires running in administrator mode (?). Configuration files should be saved to %USERHOME% instead

Monkeymerlot commented 1 year ago

Run the lithography program in Administrator mode or run notepad in administrator mode?

ciozi137 commented 1 year ago

I'm under the impression that labview/litho.exe needs to be administrator mode. And my suspicion is because of the config files. But that's just an educated guess at this point.

Monkeymerlot commented 1 year ago

Hmm, I don't think it'd be a difficult switch but let's wait until we have something stable and working. The ActiveX controls might also cause it to need Admin access.

From: Patrick Irvin @.> Sent: Wednesday, September 6, 2023 8:24:27 PM To: levylabpitt/AFM-Lithography @.> Cc: Albro, Joseph Aaron @.>; Assign @.> Subject: Re: [levylabpitt/AFM-Lithography] Administrator Mode (Issue #98)

I'm under the impression that labview/litho.exe needs to be administrator mode. And my suspicion is because of the config files. But that's just an educated guess at this point.

— Reply to this email directly, view it on GitHubhttps://github.com/levylabpitt/AFM-Lithography/issues/98#issuecomment-1709291739, or unsubscribehttps://github.com/notifications/unsubscribe-auth/AI6TZOHI2NMEAIWMSR2ONXLXZEH3XANCNFSM6AAAAAA4EXFMC4. You are receiving this because you were assigned.Message ID: @.***>

ciozi137 commented 1 year ago

I agree starting with something stable is the way to go.

Regarding the activeX I don't think the mfp3d version has this admin issue, and it uses active X

Monkeymerlot commented 1 year ago

Oh yeah that is right. From what I remember there was issues with the configuration files, and reading in the ibw and svg files but this might have changed when the setup on the computer was changed.

From: Patrick Irvin @.> Sent: Wednesday, September 6, 2023 9:05:34 PM To: levylabpitt/AFM-Lithography @.> Cc: Albro, Joseph Aaron @.>; Assign @.> Subject: Re: [levylabpitt/AFM-Lithography] Administrator Mode (Issue #98)

I agree starting with something stable is the way to go.

Regarding the activeX I don't think the mfp3d version has this admin issue, and it uses active X

— Reply to this email directly, view it on GitHubhttps://github.com/levylabpitt/AFM-Lithography/issues/98#issuecomment-1709316469, or unsubscribehttps://github.com/notifications/unsubscribe-auth/AI6TZOBGIRDGGJCIC6TCOULXZEMV5ANCNFSM6AAAAAA4EXFMC4. You are receiving this because you were assigned.Message ID: @.***>