For example in the following experiment, we wanted to go from 110 degree to 180 degree continuously in 2 min. But it stopped sweeping the angle in the middle twice, then when we hit "go to desired position" button again, it goes for sometime. For this step size is 70 degree.
But if we give the program smaller step size like 1 degree or 5 degree, it works fine (not saying that it can only take measurement for this small angle range, if we split the 70 degree in 70 part, it will do the job).
We noticed a software bug yesterday.
For example in the following experiment, we wanted to go from 110 degree to 180 degree continuously in 2 min. But it stopped sweeping the angle in the middle twice, then when we hit "go to desired position" button again, it goes for sometime. For this step size is 70 degree.
But if we give the program smaller step size like 1 degree or 5 degree, it works fine (not saying that it can only take measurement for this small angle range, if we split the 70 degree in 70 part, it will do the job).