lightaprs
commented
2 months ago Hi,
- There is no LED on board for power saving (important for solar based pico balloon flights)
- To keep board lightweight, on-board GPS antenna is passive, therefore for a GPS fix, you should test it outdoors, not indoorS. For a location beacon, GPS fix is needed.
- Check Arduino Serial Console for logs, for detailed logs enable DEVMODE
- After a GPS fix, if there is a iGate or Digipeater in your neighborhood, you should see your beacon on aprs.fi
TA2MUN
On Mon, May 13, 2024 at 9:07 PM neffen37 @.***> wrote:
hello I have a problem with a Light APRS (+WSPR) tracker 1.0 I followed the procedure to the letter I connected the two antennas with sma sockets I compiled and modified the settings that I needed I have upload the code I then connected a battery but I have nothing on the serial port no info, I checked on the card I have 3.3v there is no LED on the card? waiting for an answer. 2024-05-13.20_0521-LightAPRS-W-pico-balloon..Arduino.IDE.2.2.1.png (view on web) https://github.com/lightaprs/LightAPRS-W-1.0/assets/29715586/559a675a-9fb1-417e-9caa-09c0d02c120d 20240513_200439.jpg (view on web) https://github.com/lightaprs/LightAPRS-W-1.0/assets/29715586/5c79ff1b-2458-4d03-b9ac-c0ac9f216483
cordialy
— Reply to this email directly, view it on GitHub https://github.com/lightaprs/LightAPRS-W-1.0/issues/9, or unsubscribe https://github.com/notifications/unsubscribe-auth/ALREFUY7FVO7SVJZDA37V53ZCD6M3AVCNFSM6AAAAABHUV4DOWVHI2DSMVQWIX3LMV43ASLTON2WKOZSGI4TGNBYG44TOMQ . You are receiving this because you are subscribed to this thread.Message ID: @.***>
hello I have a problem with a Light APRS (+WSPR) tracker 1.0 I followed the procedure to the letter I connected the two antennas with sma sockets I compiled and modified the settings that I needed I have upload the code I then connected a battery but I have nothing on the serial port no info, I checked on the card I have 3.3v there is no LED on the card? waiting for an answer.
cordialy