search

lilchancep / att-pfsense-ipv6

Multiple IPv6 Prefix Delegation over AT&T Residential Gateway for pfSense
70 stars 11 forks source link

Unable to Complete Setup on OPNsense #2

Closed adam8833 closed 1 year ago

adam8833 commented 2 years ago

I'm running OPNsense and was trying to use the guide to set it up. However there are some differences that I'm having issues with. Is it possible to get a OPNsense branch set up with instructions and/or screenshots?

Nevermind: Cancel this. It turns out that with OPNsense, I don't need to do any of this. I just simply have to assign a different IPv6 Prefix ID to each VLAN and the appropriate IPv6 allow rules and it works great!

CaskAle commented 1 year ago

What did you use as prefix ids?

adam8833 commented 1 year ago

What did you use as prefix ids?

On my primary LAN (untagged VLAN), I used 0 and my other two VLANs, I used 1 and 2. That's all it took.

CaskAle commented 1 year ago

Thats great. At least it gives me hope. I am unable to do the same but i shall persevere. If you don't mind me asking, who is your service provider. AT&T for me.

adam8833 commented 1 year ago

I'm using AT&T Fiber. I've bypassed the AT&T equipment on OPNsense using https://github.com/zombielinux/pfatt/tree/supplicant

lilchancep commented 1 year ago

This method assumes that you are using the ATT hardware. I have not tested it with the supplicant method.

I used to use the bypass however att now issues new equipment that you are no longer able to bypass