set ECF_AUTO_SVC_LEVEL_DISABLED when !AUTOSVCLEVEL
20211216 SCL V8.1.1
reset elapsed time when car plugged in
J1772EvseController::Update() - just call ReadPilot() once at the top of function previously had ReadPilot() sprinkled around to try to avoid reading when not needed to save CPU cycles -> probably not necessary
20211216 SCL V8.1.0
merged in mennekes branch
20211201 SCL V8.1.0a
added ECVF_TIMER_ON so we don't have to poll to test if delay timer is on
revamp MENNEKES_LOCK
auto mode: locked when EVSE connected, unlocked when disconnected
to implement this, need to get rid of states were pilot = N12, because we can't detect connection state
don't ever set pilot to N12, even in fault states. only set to N12 in EVSE_STATE_DISABLED
always automatically unlocks in EVSE_STATE_DISABLED, even if in manual mode
add recoverable parameter to HardFault()
add volatile manual mode - when enabled, Mennekes lock is under full manual control
add S5/G5 RAPI commands to set/fetch Mennekes settings
ECVF_MENNEKES_MANUAL also reflects auto/manual mode
RAPIVER 5.2.0
usurped ECVF_AMMETER_CAL with ECVF_MENNEKES_MANUAL, so the code is currently turned off
20211201 SCL V8.0.0d
more refinements to CGMI - POST stuck relay check
20211128 SCL V8.0.0c
fixed bugs in CGMI code
20211123 SCL V8.0.0a
acpinstate: added ACPINx_OPEN
first cut for CGMI - continuous GMI support:
PD4: at any time, if PD3 is low, declare EVSE_STATE_NO_GROUND.
PD3: we will read it only when we think the relay should be open. If we detect a low state on PD4 when the relay is supposed to be open, go to EVSE_STATE_STUCK_RELAY. This is exactly the current behaviour, except that we only monitor one pin.
jeremypoulter
commented
2 years ago
20220107
ECF_AUTO_SVC_LEVEL_DISABLEDwhen!AUTOSVCLEVEL20211216 SCL V8.1.1
J1772EvseController::Update()- just callReadPilot()once at the top of function previously hadReadPilot()sprinkled around to try to avoid reading when not needed to save CPU cycles -> probably not necessary20211216 SCL V8.1.0
20211201 SCL V8.1.0a
ECVF_TIMER_ONso we don't have to poll to test if delay timer is onMENNEKES_LOCKpilot = N12, because we can't detect connection stateN12, even in fault states. only set toN12inEVSE_STATE_DISABLEDEVSE_STATE_DISABLED, even if in manual modeHardFault()S5/G5RAPI commands to set/fetch Mennekes settingsECVF_MENNEKES_MANUALalso reflects auto/manual modeECVF_AMMETER_CALwithECVF_MENNEKES_MANUAL, so the code is currently turned off20211201 SCL V8.0.0d
20211128 SCL V8.0.0c
20211123 SCL V8.0.0a
EVSE_STATE_NO_GROUND.EVSE_STATE_STUCK_RELAY. This is exactly the current behaviour, except that we only monitor one pin.SAMPLE_ACPINS#ifdef.. always sampleINVERT_V6_DETECTION: DO NOT USE