SMS not received after "SMS sent OK" message

[GoogleCodeExporter]

What steps will reproduce the problem?
1. Use example code GSM_GPRSLibrary_SMS
2. Remove the commends that will send the sms in setup
3. use valid phone number

What is the expected output? What do you see instead?
Receive an sms on a mobile. Receive nothing

What version of the product are you using? On what operating system?
BETA_GSM_GPRS_GPS_IDE100_v305.zip with Arduino UNO

Please provide any additional information below.
After messing a bit around with the hardware I finally managed to get the 
"status=READY". I then uncommented the code so an SMS would be send at the end 
of the setup. I got the "SMS sent OK" message however I never received the SMS 
on the receiving phone. I also tried the GSM_GPRSLibrary_Call code which did 
not work neither. I would suspect a signal issue however I don't know how to 
check it. The power is supplied by 2 Li-ion batteries that I got out of a 
laptop and can easily provide more than 1.3A (tested) where 1A should be 
enough. The voltage is at about 3.8V-3.84V after being regulated which should 
normally be at 3.9V. However I guess it wouldn't be a problem. Is there 
anything else I could look at? 
Thanks a lot
Alexandros

Original issue reported on code.google.com by alex10...@gmail.com on 12 Jul 2013 at 6:23

[GoogleCodeExporter]

I also have to add that the LED is not flashing which indicates that the SIM900 
is off according to the datasheet.

Original comment by alex10...@gmail.com on 12 Jul 2013 at 8:56

[GoogleCodeExporter]

Hi alex,
This issue section is not longer supported.
Please check the support page www.gsmlib.org 

Original comment by martines...@gmail.com on 10 Aug 2013 at 7:33

[GoogleCodeExporter]

Hi,
unlock pincode:)

Original comment by vykint...@gmail.com on 19 Oct 2013 at 7:42

[GoogleCodeExporter]

how can the pincode be unlocked?

Original comment by bashkey_...@yahoo.com on 6 Mar 2014 at 5:38