I am running DPPP 5.1 on a recently observed data set where two stations, namely DE602HBA and DE605HBA, are fully flagged. If I try to run ddecal calibration within DPPP it creates solutions although stations are flagged.
So clearly DE602HBA (59) and DE605HBA (62) are fully flagged.
But nevertheless if I run a calibration step "valid solutions" are created.
I use the following parsets for calibration:
Dear all,
I am running
DPPP 5.1
on a recently observed data set where two stations, namelyDE602HBA
andDE605HBA
, are fully flagged. If I try to runddecal
calibration withinDPPP
it creates solutions although stations are flagged.I checked it with the count statement:
So clearly
DE602HBA
(59) andDE605HBA
(62) are fully flagged. But nevertheless if I run a calibration step "valid solutions" are created. I use the following parsets for calibration:and
I plotted the
h5parm
phase results and I see unflagged solutions forDE602HBA
andDE605HBA
:Is there an option to enable I miss here or is this the intended behaviour?
Alex