AhoyDtu not working after adding second inv. and typing wrong serial number

[BenjiKimba]

Hardware

• [ ] ESP8266
• [x ] ESP32
• [ ] Raspberry Pi

Modelname: __ Retailer URL: __

nRF24L01+ Module

• [ ] nRF24L01+ you verified this is a Plus model capable of the required 256kBit/s mode
• [ ] square dot indicates original Nordic Semicon chip
• [ ] round dot indicates copy-cat / counterfeit SI labs chip

Antenna:

• [ ] circuit board
• [ ] external antenna (SMA)

Power Stabilization:

• [ ] 100uF Electrolytic Capacitor connected between +3.3V and GND (Pin 1 & 2) of the NRF Module
• [ ] Voltage stabilizing motherboard

Version / Git SHA:

Version: 08.83 .__ Github Hash: ___

Build & Flash Method:

• [x ] AhoyDTU Webinstaller
• [ ] VSCode - Platform IO
• [ ] Arduino
• [ ] ESP Tools

Debugging:

• [ ] USB Serial Log (attached)
• [ ] Setup settings (use our templates ... to be added)

After adding a second inverter but typing the wrong serial number, AhoyDtu is not working anymore. Using the CMT2300A and having HMS 1600-4t everythings working fine, but after adding a second HMS 1600-4t and typing in a wrong serial number, AhoyDtu is behaving bad. Everything inside is cleared, after typing in always get an error, AhoyDtu is sometimes Host and sometimes in my network.

Looking at the display it looks it always reset itself.

Serial started with 116 but I typed 166

Any idea how to solve this ?

[lumapu]

During testing I had a similar issue. This was resolved in development version only. Can you please try to install the dev version? https://fw.ahoydtu.de/fw/dev/

[BenjiKimba]

I don't now how to flash a dev. version. But after flashing 0.8.8.3 again with the web installer and typing in the right serial its working fine with 6 x HMS 1600-4t, 3 different Build's.

[Gubi2023]

try webflasher from https://fw.ahoydtu.de/tools/webflasher/ here you can choose easily each dev. or release- Version

[BenjiKimba]

Thanks !